PF 200 Series Polyester Fabric PF 200 Series is a stitch-bonded, polyester reinforcing fabric designed to strengthen joints and flashings; to be used in conjunction with our 100% silicone roof coating.
Home-Sil FR 2.00 Series Fabric Reinforcer is stitch-bonded, low profile polyester designed for use with the Home-Sil RC 32.00 Series Roof Coating roofing and waterproofing systems to form a strong yet conforming roofing membrane. Home-Sil FR 2.00 Series Fabric Reinforcer is used to increase tensile strength to moving roof joints and flashings.
Packaging Information:
Home-Sil FR 2.00 Series Fabric Reinforcer is offered in 6”, FR 2.06, and 12”, FR 2.12, rolls and are 180’ long. FR 2.06 has 6 rolls per case and 180 rolls per skid. FR 2.12 has 3 rolls per case and 90 rolls per skid.
Related
Preparation
1. Clean the substrate and remove any debris and moisture.
2. Ensure substrate is completely dry before moving to the next step.
Installation
1. Apply a base coat of silicone coating onto the substrate at approximately 10 to 15 mils
2. Extend the coating 2” on all sides of the area to receive the fabric.
3. Set the FR 2.00 Polyester Fabric Reinforcer in the wet coating and ensure there are no fish-mouths or wrinkles.
4. It is extremely important to fully saturate the FR 2.00 Polyester Fabric Reinforcer in coating from edge to edge.
5. Apply a finish coat over the FR 2.00 Polyester Fabric Reinforcer at a rate of approximately 20 to 30 mils.
6. Extend the coating past the edge of the fabric to ensure a watertight condition; any exposed fibers will wick moisture into the system.
7. An additional coat of silicone may be required under certain conditions.
Notes
1. It is crucial that all wrinkles and fish mouths be smoothed out during application. If not, the potential for failure is likely.
2. If wrinkles and fish-mouths are present after material is fully cured out, cut out wrinkle or fish-mouth and re-apply the FR 2.00 Polyester Fabric Reinforcer as described above.
Related
Can I pressure wash this product?
All of our products can be pressure washed at a low power setting (<2,500 psi) once installed and cured.
Does this product have a UL approval rating?
All of our products are UL rated when installed on a non-combustible surface.
Got more questions? Call us using the contact info here:
